GB 11566-2009 Translated English of Chinese Standard. GB11566-2009: External projections for passenger carhttps://www.chinesestandard.net, 2014 M04 18 - 21 pages This Standard specifies the general requirements, special requirements and testing methods for category M1 vehicles specified in GB 15089-2001. This Standard applies to external projections of category M1 vehicles. This Standard is valid for both of when the vehicle is stationary and when the vehicle is in motion, however, it does not apply to exterior rear-view mirrors or to the towing devices. |
Common terms and phrases
165mm diameter Annex B.2 antenna base apply article The chapter ball with diameter body-panel category M1 vehicles chapter and article circle with diameter closed position comply contact point covers and wheel described in Annex determining the floor diameter of 100 documents so quoted door ECE R26 end of bumper exhaust pipes exterior frame external surface Figure B.2 floor line gap width headlight screen height h installation instruction less than 2.5 line between O1 Luggage racks measure protruding measured according Measurement method method described method of Annex method of protruding O1 and O3 outer edge outward perpendicular protruding dimension protruding height less protruding portion provisions of 4.4 racks and ski radius of curvature rear bumper rear-view mirror refers ski racks specified Standard number support plane surface of vehicles tangent tested section type of vehicle usage position Vehicle windows vehicle’s panel vertical plane vertical projection wheel covers wheel nuts wheel ornament covers Windscreen Wipers